Army PT Body Fat Calculator

Free Body Composition Tool

Army PT Body Fat Calculator

Since July 7, 2026, the Army no longer uses body fat percentage or the tape test. Soldiers are now measured by waist-to-height ratio (WHtR): your waist at the navel divided by your height, both in inches. A result below 0.55 passes, and 0.55 or higher fails. This calculator works out your WHtR the Army way and shows the largest waist that passes at your height. A second tab runs the old one-site tape test so you can compare.

Army standard WHtR under 0.55 Same for all ages and sexes
Formula Waist ÷ height Waist at the navel, in inches
Tape test Rescinded Army Directive 2026-13
  • Updated for the July 2026 WHtR standard
  • Runs in your browser. Nothing is sent or stored
  • Last updated: September 2026
1 Height
ft
in

Measure height in socks, without shoes, standing straight.

2 Waist at the navel
in
in
in

Your Army WHtR result

—

Waist-to-height ratio standard: under 0.55

—

—

Largest passing waist at your height

—

—

Waist used—
Height used—
Margin to 0.55 line—
General health band (NICE)—
Your WHtR on the Army scale Band: passing zone, below 0.55
0.400.4750.550.6250.70

    This is an unofficial self-check. Your official result is the one recorded by your unit’s trained measurement team on DA Form 5500.

    What Is the Army PT Body Fat Calculator?

    An Army PT body fat calculator checks whether a Soldier meets the Army’s body composition standard. For years, this meant estimating body fat percentage with a tape measure. That changed on July 7, 2026.

    Under Army Directive 2026-13, the Army replaced height and weight tables, the tape test and supplemental body fat scans with one measurement: the waist-to-height ratio (WHtR). So today, an accurate Army body fat calculator is really an Army body composition calculator. It divides your waist by your height and checks the result against 0.55.

    This tool does two jobs:

    • Army WHtR check: your ratio, pass or fail, and the largest waist that passes at your height.
    • Old tape test comparison: your body fat under the retired one-site formula, next to your new WHtR. It shows whether the new rule helps or hurts you.

    How to Use the Army Body Composition Calculator

    The first tab works as an Army WHtR calculator, also called an Army waist to height ratio calculator.

    1. Enter your height in feet and inches, inches, or centimetres. Measure in socks, without shoes.
    2. Enter your waist at the navel. Add up to three readings for a more reliable average, like the official Army body composition test.
    3. Keep “Use Army rounding” ticked to copy how readings are recorded. Untick it to see your exact ratio.
    4. Read your result: your WHtR to three decimal places, pass or fail, the largest passing waist for your height, and how far you are from the line.
    5. Optional: open the second tab to compare with the old tape test.

    How Is the Army Waist-to-Height Ratio Calculated?

    The Army WHtR formula is simple:

    WHtR = waist circumference at the navel (in) ÷ height (in)

    The Army records the waist-to-height ratio to three decimal places and does not round it. Any digits after the third decimal place are dropped. The Army’s own FAQ gives the example: 0.549 passes, and 0.550 fails.

    Army waist measurement

    The waist is measured around the body at the navel (belly button), in inches. This is the same site the one-site tape test used, so most Soldiers already know it.

    Army height measurement

    Height is measured in inches, standing straight, without shoes. Published unit guidance says height is recorded to the nearest half inch.

    Worked examples

    • 5 ft 9 in (69 in), waist 37 in: 37 ÷ 69 = 0.536. Pass.
    • 5 ft 6 in (66 in), waist 36.5 in: 36.5 ÷ 66 = 0.553. Fail, even though the waist is smaller.
    • 6 ft 0 in (72 in), waist 39.5 in: 39.5 ÷ 72 = 0.548. Pass, but only just.

    What Is the Current Army Body Composition Standard?

    The current Army body composition standard is a WHtR below 0.55. This is often called the Army 0.55 standard. It applies to every Soldier, whatever their age or sex. It also applies to West Point and Senior ROTC cadets.

    • Effective date: July 7, 2026.
    • What it replaced: height and weight screening tables, the circumference tape test and supplemental body fat assessments.
    • How often: all Soldiers are screened twice a year. Soldiers had 90 days to get a first WHtR screening recorded.
    • No fitness exemption: the old exemption for scoring 465 or more on the Army Fitness Test (AFT) has been rescinded.
    • Spacing: units must allow at least seven days between a Soldier’s AFT or CFT and their WHtR screening.
    • Exempt: pregnant and postpartum Soldiers keep their existing medical exemptions.

    So the old Army body fat standards (20% to 26% for men and 30% to 36% for women, by age) no longer decide pass or fail. The Pentagon asked all services to move to WHtR. The Navy, Air Force and Space Force also use 0.55, and the Marine Corps chose a stricter 0.52.

    Army WHtR standard: largest passing waist by height

    The table shows the largest waist that passes at each height, in half-inch steps. The last column is the exact 0.55 line. Your waist must be below it.

    HeightLargest passing waistWaist must be under
    4 ft 10 in (58 in)31.5 in31.90 in
    4 ft 11 in (59 in)32.0 in32.45 in
    5 ft 0 in (60 in)32.5 in33.00 in
    5 ft 1 in (61 in)33.5 in33.55 in
    5 ft 2 in (62 in)34.0 in34.10 in
    5 ft 3 in (63 in)34.5 in34.65 in
    5 ft 4 in (64 in)35.0 in35.20 in
    5 ft 5 in (65 in)35.5 in35.75 in
    5 ft 6 in (66 in)36.0 in36.30 in
    5 ft 7 in (67 in)36.5 in36.85 in
    5 ft 8 in (68 in)37.0 in37.40 in
    5 ft 9 in (69 in)37.5 in37.95 in
    5 ft 10 in (70 in)38.0 in38.50 in
    5 ft 11 in (71 in)39.0 in39.05 in
    6 ft 0 in (72 in)39.5 in39.60 in
    6 ft 1 in (73 in)40.0 in40.15 in
    6 ft 2 in (74 in)40.5 in40.70 in
    6 ft 3 in (75 in)41.0 in41.25 in
    6 ft 4 in (76 in)41.5 in41.80 in
    6 ft 5 in (77 in)42.0 in42.35 in
    6 ft 6 in (78 in)42.5 in42.90 in
    6 ft 7 in (79 in)43.0 in43.45 in
    6 ft 8 in (80 in)43.5 in44.00 in

    How to Measure Your Waist for the Army WHtR Test

    A good self-measurement helps you avoid surprises on screening day. The Army’s FAQ says only that the waist is measured at the navel, in inches. Published unit guidance (HQDA EXORD 182-26, Annex A, as reported by Soldier-focused sites) adds these steps for the Army body composition measurement:

    1. Wear PT shorts and a T-shirt. Lift or tuck the shirt. No shapewear or tight undergarments.
    2. Stand relaxed, feet together, arms at your sides. Do not suck in your stomach.
    3. Place the tape at the navel, level all the way round and parallel to the floor. Use a mirror or a partner to check the back.
    4. Keep the tape snug on the skin, without pressing into it.
    5. Take three readings. Each one is recorded rounded down to the nearest half inch.
    6. If one reading is more than 1 inch different from the others, take a fourth and average the three closest.

    Why waist measurement at the navel matters

    Health guidelines often measure the waist halfway between the lowest rib and the top of the hip bone. The Army uses the navel instead. On many people the navel sits lower and gives a larger reading, so use the Army site when you practise.

    Army WHtR Pass or Fail: What Does Your Result Mean?

    Army WHtR resultWhat it means
    0.549 or lowerPass. You meet the Army body composition standard.
    0.550 or higherFail on first screening. A second measurement by a different team follows on the same duty day.

    If the second measurement also comes out at 0.550 or higher, the Army body composition assessment leads to:

    • Enrollment in the Army Body Composition Program (ABCP) and a flag.
    • A commander-directed medical exam for Active Component and AGR Soldiers, to rule out medical causes.
    • Staying in the ABCP until you meet the WHtR standard.

    The Army is running a 180-day review of the new standard. No Soldier will be separated for failing WHtR until that review is finished and new guidance is issued.

    What WHtR says about health

    Outside the Army, the UK’s National Institute for Health and Care Excellence (NICE) uses WHtR as a health screen. It groups results as 0.40 to 0.49: healthy, 0.50 to 0.59: increased risk, and 0.60 or more: high risk. WHtR is a screening measure, not a diagnosis. Your doctor can tell you what your number means for you.

    Old Army Tape Test vs. New WHtR Standard

    From June 2023, the Army tape test was a one-site test. It used your weight and your abdomen at the navel to estimate body fat percentage. The second tab of this tool is an Army tape test calculator that uses those formulas, so it also works as the old Army body fat calculator.

    Men: body fat % = −26.97 − (0.12 × weight in lb) + (1.99 × abdomen in inches)
    Women: body fat % = −9.15 − (0.015 × weight in lb) + (1.27 × abdomen in inches)
    AgeOld limit: menOld limit: women
    17–2020%30%
    21–2722%32%
    28–3924%34%
    40 and over26%36%

    The change cuts both ways. Two 30-year-old men, both 5 ft 10 in (70 in):

    • 190 lb, 38 in waist: the old test gave 25.9% body fat, a fail (limit 24%). The new WHtR is 0.542, a pass.
    • 240 lb, 40 in waist: the old test gave 23.8%, a pass, because the formula lowers the estimate for heavier Soldiers. The new WHtR is 0.571, a fail.

    So heavier, muscular Soldiers with a large waist may find the new rule harder. The Army says it chose WHtR because it predicts health risk better, is fairer across body types and is simpler. It also no longer uses an Army body fat percentage calculator for any official decision.

    Army Body Composition Calculator FAQs

    Is the Army PT body fat calculator still based on body fat percentage?

    No. Since July 7, 2026, the Army uses waist-to-height ratio only. Body fat percentage, the tape test and height and weight tables have all been rescinded. An up-to-date Army PT body fat calculator checks WHtR against 0.55.

    What WHtR do I need to pass?

    Below 0.55. The ratio is kept to three decimal places without rounding, so 0.549 passes and 0.550 fails.

    What is the largest waist I can have at my height?

    Multiply your height in inches by 0.55. Your waist must be below that number. At 5 ft 10 in (70 in), the line is 38.5 inches, so the largest passing half-inch reading is 38.0 inches.

    Does a high AFT score exempt me from WHtR?

    No. The exemption for Soldiers scoring 465 or more on the AFT has been rescinded. Every Soldier must meet the WHtR standard.

    Can I ask for a tape test or body fat scan instead?

    No. The Army’s FAQ states that WHtR is the only authorized body composition assessment. Supplemental body fat assessments are no longer used.

    Is the WHtR standard different for men and women?

    No. The same 0.55 standard applies to all Soldiers, with no separate limits by sex or age. Pregnant and postpartum Soldiers keep their medical exemptions.

    How accurate is this Army WHtR calculator?

    The maths is exact. The result is only as good as your measurements. Practise measuring at the navel with the tape level, and take three readings. Your official result is the one your unit records.

    Sources and References

    1. US Army. Army Body Composition Program and Standards: Frequently Asked Questions (effective July 7, 2026). army.mil (PDF)
    2. US Army. Army modifies body composition program, adopts waist-to-height ratio. July 2026. army.mil
    3. Stars and Stripes. Army releases new body fat standards following Pentagon order. July 7, 2026. stripes.com
    4. Task and Purpose. Army rolls out rules on waist-to-height body standards. 2026. taskandpurpose.com
    5. AFT Score Calculator. Army WHtR measurement procedure: EXORD 182-26 Annex A guide (secondary summary of unit measurement steps). aftscorecalculator.com
    6. US Army Garrison Fort Jackson. FY23 newsletter: one-site tape test and body fat formulas. home.army.mil (PDF)
    7. National Institute for Health and Care Excellence. Obesity: identification, assessment and management, 2022 update (waist-to-height ratio categories). Summary: Waist-to-height ratio (Wikipedia)

    Reviewed and updated: September 2026. Army policy is under a 180-day review, so check for newer guidance.